Table of Contents
Advertisement
heating a room.
• Do not use the oven door handles to lift or move the
appliance.
• All possible measures have been taken to ensure
your safety. Since the glass may break, care should
be taken while cleaning to avoid scratching. Avoid
hitting or knocking the glass with accessories.
• Make sure that the supply cord is not trapped or
damaged during installation. If the supply cord is
damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in
order to prevent a hazard.
• Do not let children climb on the oven door or sit on it
while it is open.
• Please keep children and animals away from this
appliance.
1.2 inStallation WarninGS
• Do not operate the appliance before it is fully
installed.
• The appliance must be installed by an authorised
technician. The manufacturer is not responsible
for any damage that might be caused by defective
placement and installation by unauthorised people.
• When the appliance is unpacked, make sure that
it is has not been damaged during transportation.
In case of any defect do not use the appliance
and contact a qualified service agent immediately.
The materials used for packaging (nylon, staplers,
Styrofoam, etc.) may be harmful to children and they
should be collected and removed immediately.
• Protect your appliance from the atmosphere. Do not
expose it to effects such as sun, rain, snow, dust or
excessive humidity.
EN - 6
Advertisement
Table of Contents
Need help?
Do you have a question about the K-60D19BM1-EN and is the answer not in the manual?
Questions and answers
How do you replace the outer glass assembly
To replace the outer glass assembly on a Sharp K-60D19BM1-EN:
1. Remove the glass by pulling it out in the direction of A after releasing it from the location bracket (x).
2. To replace, push the glass toward and under the location bracket (y) in the direction of B.
3. Then, place the glass under the location bracket (x) in the direction of C.
If the oven has a triple glass door, the third glass layer can be removed and replaced in the same way as the second layer.
This answer is automatically generated