Table of Contents
Advertisement
Installation in a wall unit
After making the electrical connections,
insert the oven into the cabinet by pushing
it forward. Open the oven door and insert
2 screws in the holes located on the oven
frame. While the product frame touches the
wooden surface of the cabinet, tighten the
screws.
2.3 eleCtriCal ConneCtion anD Safety
WARNING: The electrical connection
of this appliance should be carried out
by an authorised service person or
qualified electrician, according to the
instructions in this guide and in compliance
with the current local regulations.
WARNING: THE APPLIANCE MUST
BE EARTHED.
•
Before connecting the appliance to the
power supply, the voltage rating of the
appliance (stamped on the appliance
identification plate) must be checked for
correspondence to the available mains
supply voltage, and the mains electric
wiring should be capable of handling the
K
F
I
G
EN - 10
A
E
D
J
appliance's power rating (also indicated
on the identification plate).
•
During installation, please ensure
that isolated cables are used. An
incorrect connection could damage
your appliance. If the mains cable is
damaged and needs to be replaced
this should be done by a qualified
personnel.
•
Do not use adaptors, multiple sockets
and/or extension leads.
•
The supply cord should be kept away
from hot parts of the appliance and must
not be bent or compressed. Otherwise
the cord may be damaged, causing a
short circuit.
•
If the appliance is not connected
to the mains with a plug, a all-pole
disconnector (with at least 3 mm contact
spacing) must be used in order to meet
the safety regulations.
•
The appliance is designed for a power
supply of 220-240V ~ and 380-415V
3N~. If your supply is different, contact
the authorised service person or a
qualified electrician.
•
The power cable (H05VV-F) must be
long enough to be connected to the
appliance, even if the appliance stands
on the front of its cabinet.
•
Ensure all connections are adequately
tightened.
B
C
C
Advertisement
Table of Contents
Need help?
Do you have a question about the K-60D19BM1-EN and is the answer not in the manual?
Questions and answers
How do you replace the outer glass assembly
To replace the outer glass assembly on a Sharp K-60D19BM1-EN:
1. Remove the glass by pulling it out in the direction of A after releasing it from the location bracket (x).
2. To replace, push the glass toward and under the location bracket (y) in the direction of B.
3. Then, place the glass under the location bracket (x) in the direction of C.
If the oven has a triple glass door, the third glass layer can be removed and replaced in the same way as the second layer.
This answer is automatically generated