To Check And Adjust Temperature Settings - Waterco 200386 Installation And Operation Manual

I pg 24
Pool Heat Pump

To Check and Adjust Temperature Settings

To program the desired water temperature, press BOTH the UP and DOWN arrow keys at
the same time until the temperature degree displays change degree, then release them.
Press the UP arrow or DOWN arrow to program the desired temperature. The temperature
setting will automatically flash and will be saved. The display temperature will be revert
back to the pool water temperature when all keys have remained untouched for 5
seconds.
To change the temperature display from Fahrneheit (˚F) to Celcius (˚C). Press, the
button ˚C/˚F. The led below the ˚F or ˚C will be lit to indicate the current selection.
Note: The pool heat pump will cut out at once when the programmed temperature has
been reached.
Electronic Control Reversible (XLR) electronic control
with diagnostics with diagnostics
In addition to controlling the temperature of the water, this electronic control
informs you on the operation of your pool heat pump or any faults that may arise
by displaying codes on the temperature display.
When the unit is in defrost mode the code "DEF" is dispalyed on the temperature
display. This under normal conditions is not considered to be a fault.