Controller Functions; Operation Modes; Operation Settings; Timer Operation - Waterco Electroheat ECO-V 17kW Installation And Operation Manual

17 I Pool Heat Pump

Controller Functions

Operation Modes

Automatic mode symbol
Cooling mode symbol
defrosting symbol
Heating mode symbol

Operation Settings

Temperature setting symbol, the figure under is the temperature value.
Inlet water temperature symbol, the figure under is the temperature value.
Parameter number symbol, the figure under is the parameter number.
Outdoor ambient temperature symbol, the figure under is the temperature value.
Parameter value symbol, the figure under is the parameter value.
Failure symbol.

Timer Operation

Turning on timer symbol. It appears when setting turn on timer.
Turning off timer symbol. It appears when setting turn off timer.
Clock symbol. It appears when setting time.

Water Temperature Setting

When the heat pump is switched on, just press
When outlet water temperature is reset, the display will automatically return to normal
display and resetting is activated.
or to adjust water temperature.

Function Descriptions

1. When power to the unit is switched on the controller display will illuminate.
2. use the uP and dOWN arrow buttons on the keypad to adjust. Adjustable
functions: For users, the current temperature, flash, " " and " " to adjust, press
ON/OFF button to return to the current status. To fully adjust cooling, heating,
automatic temperature, users need to enter cooling, heating and automatic mode
respectively for adjustment.
3. In auto mode, the units operating speed is displayed on screen.
4. backlight will be illuminated when buttons are pressed. backlight will be turned off
if button is not pressed in 1 minute.

Buzzer

under any operation, a buzzer will sound when any button on the keypad is pressed.
When the unit reports a fault the buzzer will be silent and the code will be displayed
on the controller screen.

Memory Function

The heat pump controller should memorise ON / OFF status, operating mode,
parameter and timer settings. When power is connected and the heat pump is
switched on, the unit will start operation based on the settings when power was
switched off previously.
Pool Heat Pump I 18