Section 1 - Installing Mounting Brackets - Draper FlexStyle Cassette Motorized I/O AC Installation & Operation Instructions

FlexStyle Cassette Motorized
®

Section 1 - Installing Mounting Brackets

IMPORTANT: Mounting Brackets must be installed parallel, plumb, and square, with a tolerance of +/- 1/ 8 "
Verify unit measurements and ensure unit will fit in the desired location.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
1.
Mark wall, jamb, or ceiling for placement of
mounting brackets.
Please Note:
Brackets should be installed far enough from the ceiling
or wall
(wall mount) (ceiling mount)
the brackets fit. Tabs may then be removed
Please Note:
Brackets should be installed no more than 5"
in from ends of Cassette Assembly. If provided, center
bracket should be mounted in center of the case.
(Idler Bracket shown.)
that the tabs on top of
(if desired)
(127mm)
3.
Attach brackets using
appropriate fasteners
for mounting
(by others)
surface.
AC
2.
Drill small starter hole
in mounting surface
(if necessary)
.
4.
If tabs are visible above
the window, they may be
removed
.
.
(if desired)
page 3 of 8
.
(3mm)