Properties; About Properties; Property 0X00 - Main Firmware Id; Property 0X02 - Usb Polling Interval - Magtek iDynamo 5 Gen III Programmer's Manual

6 - Properties

6 Properties
6.1

About Properties

Properties are used to provide information about the device and how to configure it. Secured properties
are set at the factory or by an administrator using software tools supplied by MagTek. Property values
take effect immediately unless specified otherwise.
6.2 Property 0x00 – Main Firmware ID
Property ID: 0x00
Property
ASCII
Type:
Length: Varies
Get Property: Yes
Set Property: No
Default
Part number of installed firmware
Value:
This read-only property returns the main firmware part number, a dash, the major and minor revision
number, followed by a dash and the firmware type. {main firmware part number}-{3 character rev}-
{type}
Table 6-1 - 0x00 –Main Firmware ID Property Example
1000004854-AD9-PCI
6.3

Property 0x02 - USB Polling Interval

Property ID: 0x02
Property
Byte
Type:
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default
0x01
Value:
This one-byte value (1-255) sets the device's polling interval in milliseconds for the Interrupt in
Endpoint. The device sends the value of this property as part of USB device enumeration to the host.
iDynamo 5 Gen III| Secure Card Reader | Programmer's Manual (COMMANDS)
Property Description
Example
Property Description
Page 29 of 48 (D998200587-101)