ePropulsion eLite Quick Start

Hide thumbs Also See for eLite:

Download this manual

Charging Port

Kill Switch

Throttle

Clamp Bracket

Trim Pin

User Manual

Before first use, please ensure that you have read the user manual and thoroughly understand

the potential risks related to the operation of the equipment.

Before first use, please fully charge the outboard motor.

Warning:

• Please always wear a life jacket before boating, and tie the kill switch lanyard to your wrist or

life jacket.

• Before each trip, always check the status of the outboard motor and the battery level.

• After use, please remove the kill switch, press and hold the power button for 2 seconds to turn

off the motor. All parts of the outboard that have been underwater, or splashed, should be

rinsed with fresh water after each use.

eLite Quick Start

Operation Video

Display

USB Type-C Output

Tiller Angle

Adjustment Toggle

Bracket Disassemble

Button

Need help?

Do you have a question about the eLite and is the answer not in the manual?

Page 1 Quick Start Display USB Type-C Output Charging Port Kill Switch Tiller Angle Adjustment Toggle Bracket Disassemble Button Throttle Clamp Bracket Trim Pin User Manual Operation Video Before first use, please ensure that you have read the user manual and thoroughly understand the potential risks related to the operation of the equipment.
Page 2 1 Mount the Clamp Bracket Before mounting, please check the clamp bracket . Place the clamp bracket in the center on the transom and rotate the tightening handle to lock. 2 Tiller Angle Free Mode Rotate the tiller adjustment toggle 90° in either direction. The toggle will spring outwards as it’s rotated and the tiller can then be adjusted freely to any angle from -90°...
Page 3 3 Installation and Removal Motor Installation Step 1: Pull out or rotate the tiller Step 2: Hold the outboard motor with both adjustment toggle to unfold the tiller. hands and align the quick-release mount with the clamp bracket damping shaft, then slowly lower the motor into place.
Page 4 充电显示 -90° 5 Trim and Tilt Angle Trim Angle Step 2: Adjust the trim angle of the outboard Step 1: Push the trim pin inward and rotate it motor as desired and insert the trim pin into 180°, with the handle facing upward. Pull out the corresponding limit hole.