Omron ZFX-C Command Reference Manual page 17

Executing Measurement < MEASURE command >
Executing a Single Measurement
This command executes a single measurement.
< Command format >
or
M E A S U R E C R
< Response format >
When processing ends successfully
Measurement value
O K C R
When processing fails
E R C R
< Explanation of parameters >
Measurement value The acquired measurement value is returned. The measurement value is output in the
format (ASCII/binary) specified in the output conditions.
Important
Measurement values are output only when an expression is set at [Setup] - [Support] - [Calculation] - [Data], and [RS-
232C/422] or [USB] is specified at [System] - [Output] - [Data output].
ZFX-C Serial Communication Command Reference
M C R
C R
Configuration of Measurement Value Data p.8
About Communication Commands
15