Setting Flowchart - Omron WT30 Operation Manual

Setting Flowchart

3-3

Setting Flowchart

Using unregistered
communications partner
2
Make operation settings.
(1) I/O Slave Station settings
· Set node number.
· Set frequency channel.
(2) Serial Master Station settings
· Set node number.
· Set frequency channel.
WT30 Utility
WT30-TOOLS
The setup procedure for the WT30 is described below. To perform simple
communications without registering I/O Slave Stations, perform the following
settings omitting step 2.
1
Monitor received signal
strength to find unused
frequency.
The WT30-TOOLS can also be used.
2
Register
communications partner.
3
Make operation settings.
4
Check communications
status.
The WT30 utility called WT30-TOOLS can be downloaded free of charge from the OMRON
website. Be sure to read the software licence agreement before downloading the utility.
Common Settings for Serial Master
and I/O Slave Stations
· Set frequency channel.
· Check RSSI level.
(1) I/O Slave Station settings
· Set node number.
· Set frequency channel.
(2) Serial Master Station settings
· Set node number
(i.e., number of nodes in network).
· Set frequency channel.
· WS indicator lit green.
· RSSI flashing green.
Serial Master Station settings
· Enable/disable scan list
Confirmation at I/O Slave Station
· Check that MS and WS indicators
are lit green.
· Check RSSI level.
Confirmation at Serial Master Station
· Check that MS and WS indicators
are lit green.
· Set the node number.
· Check RSSI level.
Section 3-3
Check the installation location's
electromagnetic wave status and find
an unused frequency. Confirm using
the RSSI on the Serial Master
Station or I/O Slave Station.
Register the I/O Slave Stations in the
Serial Master Station.
Execute scan list registration to
register the I/O Slave Station data
(serial number and I/O size) in the
Serial Master Station. Set the number
of Stations to register using the Serial
Master Station's node number setting.
Make each of the settings using the
function setting switch.
When the Serial Master Station's scan
list is enabled, communications are
performed with the specified I/O Slave
Stations registered in step 2.
When the scan list is disabled,
communications are performed with
the number of I/O slave Stations set
on the Serial Master Station's node
number switch. For example, if node
number 3 is set, communications are
performed with I/O Slave Stations 1 to
3.
Check whether communications are
normal using the RSSI and WS (wire-
less network status) indicators on the
Serial Master Station or I/O Slave Sta-
tions.
41