Clearing The Recorded Peak Values For The Received Signal Strength - Omron WT30 Operation Manual

Monitoring Unused Frequencies
3-2-3 Clearing the Recorded Peak Values for the Received Signal
Strength
1,2,3...
40
Use the following procedure to clear the peak values recorded for all the chan-
nels.
1. Set the function setting switch as follows:
Bit 4: ON (field strength monitor disabled)
ON
1 2 3 4 5 6 7 8 9 0
2. Change the setting for the mode setting switch from RUN mode to TEST
mode.
RUN
TEST
SET
3. Change the setting of the special function switch as follows:
ENTER
ON
OFF → ON → OFF
OFF
4. Confirm that data has been cleared using the RSSI. The RSSI's green in-
dicators will flash 4 or 5 times to indicate that data has been cleared.
RSSI display: Green indicators flashing
Section 3-2