Nomenclature And Functions; Wt30 Terminals: Serial Master Stations - Omron WT30 Operation Manual

Nomenclature and Functions

1-2

Nomenclature and Functions

1-2-1

WT30 Terminals: Serial Master Stations

Appearance
Mode selection switch
Serial Communications
Setting Switch
Set the baud rate.
Power supply terminal
Supply power to the Unit.
Settings
Unit No. Switch
6
W T 3 0
- M 0 1
- F L K
Antenna terminal (ANT1)
ANT1
Status indicators
PWR
MODE
RUN
TEST
SET
ON
DC24V 0V
WT30-M01-FLK
Set the unit number for the Serial Master Station. The setting is read when the
power is turned ON. The default is 00.
UNIT No.
X10 X1
Unit No. switch
Set the unit number of the Serial Master Station.
This is used for Host Link communications.
Node setting switch (WNODE)
Set the number of connected I/O Slave Stations.
Channel setting switch (WCH)
Set the communications frequency.
ANT2
RSSI
1 9
COMM MS WS
UNIT No.
W NODE W CH
ENTER
ON
x10 x1 x10 x1 x10 x1
OFF
ON
RS-232C
MODE FUNCTION
RS-232C
RS-232C terminal
Connect the PLC, personal computer, etc.
Section 1-2
Antenna terminal (ANT2)
Received signal
strength indicator
Special function switch
Function setting switch
Make the detailed settings
for RUN/TEST/SET mode.