Table of Contents
Advertisement
OPERATION
Remote control
Plastic tab
Pull
Remote control
bottom
Remote control
bottom
Operation of remote control
Preparing the remote control
The DVD player comes with a remote control. Simply pull out the plastic tab in
the remote control to activate the battery. The plastic tab - which covers the bat-
tery terminals - extends the life of the battery.
Note: Please note that some models will not include this plastic tab. If this is the
case, please refer to the next section for battery installation.
Replacing the battery
If the remote control only operates when you get closer to the device, it means
that the battery has been used up. Please replace the battery with a new Lithi-
um battery (CR2025, 3V). To replace the remote control's battery, the battery
holder must be removed. Be sure to take note of the polarity marking on the bat-
tery. The " + " side must face the bottom of the remote (the side without any but-
tons).
1. Use your thumbnail to slide the clip on the battery holder to the right side
and pull out the battery holder simultaneously in order to remove the battery
compartment.
2. Insert a new battery into the battery holder. Make sure that the positive side
(marked on the battery as "+") is facing upwards.
3. Reinstall the battery holder into the remote control to complete the battery
installation.
14
Advertisement
Table of Contents
