Replacing Battery; To Use The Remote Control; Installing The Remote Control Battery; Operating The Remote Control - CyberHome CH-DVD 300 Operation Manual

To use the remote control

The DVD player comes complete with a remote control. Just
pull the plastic tab in the remote control to activate the battery.
The plastic tab - which covers the battery terminals - extends
the life of the battery. *Please note that some models will not
include this plastic tab. If so please refer to the next section for
battery installation.
Remote Control
Plastic Tab
Replacing the remote control battery
To replace the remote control's battery, the battery holder must
be removed. Be sure to take note of the polarity marking on the
battery. The " + " side must face the bottom of the remote (the
side without any buttons).
1
To access the Battery, remove the Battery Holder
from the remote control. To remove the battery
holder, use your thumbnail to squeeze the Release
Clip in toward the center, while simultaneously
pulling the Handle out with your index fingernail, as
depicted below:
Remote Control
GETTING STARTED
Pull
Battery Holder
Release Clip Handle
6
2
Place the battery into the holder as pictured below
2 2
with the POSITIVE SIDE (marked on Battery as " +")
facing upwards and insert into the remote control to
complete the battery installation.
+

Operating the remote control

When using the remote control, be sure to stay within a 30
degree angle of the sensor on the receiver. Keep in mind that
any obstructions between the remote control and the receiver
will affect performance.
CH-DVD 300
Notes on battery
If the remote control functions better when it is closer to
the unit, the battery may need to be replaced.
In case of any leakage of the battery, dispose of the battery
right away and avoid touching the chemical discharge.
Make sure to clean the remote control's battery
compartment before installing a new battery.
6
Battery
+
TM TM TM TM
30 30
TM TM