Omron NT-SERIES - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 67

Operation of Screen Data (Application) File
NT30, NT30C, NT620S, NT620C, NT625C
S Printer
Select one of the Supported printers from the printer drop-down list box.
Although this setting is possible for NT31, NT31C, NT631, NT631C, it is not
valid from Support Tool.
Please set from the Maintenance Mode of PT.
S Mode
Color:
Specify "Color" for color printing.
Designation of Color is valid for the following PT models.
NT30C, NT620C, NT625C
S Tone:
Specify "Tone" for monochrome printing.
If a color type PT is used with Tone set for [Mode], color data is expressed using
a gray scale, printed in monochrome.
These setting are available for the following PT models.
NT30, NT30C, NT620S (Printer only), NT620C, NT625C
For NT21, NT31, NT31C, NT631, and NT631C, this setting has to be selected
from PT.
Numeral Storage Type
BCD or Binary can be selected for the storage type of the Numeral memory table.
This setting is available only when the time the Storage Type in the Numeral
memory table has [System] setting. When BCD or Binary is set for Numeral
memory table Storage Type, this setting in the PT Configuration will be ignored
and follows the storage type in the Numeral Table.
This setting is available for the following PT Model.
NT21, NT31, NT31C, NT631, NT631C
S Control/Notify Area page
The Control/Notify Area page is displayed when you click on the [Control/Notify
Area] tab.
The Control/Notify Area page is prepared to set the PT Control area, control-
ling PT from PC (PLC) and for PT Notify Area, notifying PT information to a PC
Section 3-3
51