Omron NT-SERIES - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 510

NT Transfer Utility
Device necessary for transmitting screen data
Installing the NT Transfer Utility
Installation
Reference: The basic operation of the install program is same as the install program of the
Reference: You can execute the setup program by double clicking Setup.exe for NT Transfer
494
S RS-232C cable
The cable used for the Support Tool can be used.
For cable specifications, refer to Appendix J Connecting Cable Specifications.
Install the NT Transfer Utility in the personal computer that is to be connected to a
PT on site. NT Transfer utility operates alone. You do not need to pre-install the
Support Tool in the personal computer.
To install the NT Transfer Utility, execute the install program that is in your soft-
ware package.
Support Tool. Refer to 2-2-1 Basic Installation Operation.
S Procedure
(1) Start up Windows.
When using Windows 2000, Windows XP, Windows Vista, or Windows 7, log
in with a user ID in the administrators group.
(2) If you are using CD-ROM, set the Support Tool CD-ROM in the CD-ROM
drive while holding down the Shift key to prevent the Support Tool setup pro-
gram from starting up. (Release the Shift key after CD-ROM is recognized
and the access to the CD-ROM is stopped.) If the Support Tool setup pro-
gram is automatically started, click on
Utility in the Support Tool system disk by displaying the Windows Explorer. In this
case, steps 3, 4 and 5 bellow can be skipped.
(3) Click on the Start button of Windows and select "Run..."
Appendix C
to abort it.