Yolink YS5003-UC Installation & User Manual page 25

Control D2D, Continued
Q
Testing
1. Ensure the valve is in the normal (open)
position.
2. Test the water leak sensor (if needed, refer to
the sensor user guide for testing instructions).
3. Verify that the valve closes immediately when
the leak sensor is activated.
Unpairing
1. At the Water Leak Sensor, press and hold the
SET button for 10-15 seconds, until the LED
quickly blinks green then red, then release the
button.
2. At the Valve Controller 2, press and hold the
SET button for 10-15 seconds, until the LED
quickly blinks green then red, then release the
button.
Upon unpairing, either the Water Leak Sensor
LED or the Valve Controller 2 LED will stop
blinking and turn off.
At this time, you can test the leak sensor to
confirm it no longer activates the valve
controller. If you also have any automations or
alarm strategies that may also control the valve
controller, disable them before testing.
23