Operating Procedures
■ Setting Procedure Guide
Settings for Counter Operation
(1-stage/2-stage Counter, Total and Preset Counter, Batch Counter, Dual Counter)
● Using Basic Settings Only
Basic Settings
Counting speed (30 Hz, 5 kHz)
Input mode (UP, DOWN)
Output mode (N, F, C, K-1)
One-shot output time (0.5 s, 0.05 s)
Reset input signal width (20 ms, 1 ms)
NPN/PNP input mode (NPN, PNP)
● Using Input Modes Not Given Above (Up/Down A,
Up/Down B, Up/Down C) , Output Modes
(R/P/Q/A/K-2/D/L/H), or (OUT2) Output Time
Set all functions with the operation keys.
For details on the setting methods,
refer to page 10.
Note: The default setting is for a 1-stage preset counter. (For models with a 2-stage setting, the default is a 2-stage preset counter.)
Setting for Tachometer Operation
● Using Basic Settings Only
Basic Settings
Counting speed (30 Hz, 10 kHz)
Output mode (HI-LO, AREA, HI-HI, LO-LO)
Average processing (OFF, 2, 4, 8 times)
NPN/PNP input mode (NPN, PNP)
● Performing Advanced Settings: Decimal Point Position, Prescale Value, Auto-zero Time, Startup Time,
Display Color, or Key Protect Level
Settings other than the basic functions above can be
performed with the operation keys.
For details on the setting methods, refer to page 20.
Note: The default setting is for a 2-stage preset counter.
8
Multifunction Counter
The settings can be made
easily with the DIP switch.
For details on the setting
methods, refer to page 9.
(H7BX-AW@ only)
The settings can be made
easily with the DIP switch.
For details on the setting
methods, refer to page 19.
H7BX
ON
OFF
● Performing Advanced Settings: Dual Count Calculating
Mode, Output 1 Time, Decimal Point Position, Prescale
Value, Display Color, or Key Protect Level
Settings other than the basic functions above
can be performed with the operation keys.
For details on the setting methods,
refer to page 10.
ON
OFF
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8