Omron H7BX Datasheet page 16

Reset/reset 1
999999
Set value 2
Set value 1
K-2 0
99999
OUT1
OUT2
Reset/reset 1
999999
Set value 2
Set value 1
0
D
99999
OUT1
OUT2
Output
mode
setting
Reset/reset 1
999999
Set value 2
Set value 1
L 0
99999
OUT1
OUT2
Reset/reset 1
999999
Set value 2
Set value 1
H 0
99999
OUT1
OUT2
Note 1. Counting cannot be performed while the reset/reset 1 input is ON.
2. If reset/reset 1 input turns ON while the one-shot output is ON, the one-shot output turns OFF.
3. If there is power failure while the output is ON, the output will turn ON again when the power supply has recovered. For a one-shot output, the output will turn
ON again for the duration of the output time setting once the power supply has recovered.
4. Do not use the counter function in applications where the count may be completed (again) while the one-shot output is ON.
5. The set values are between 99999 and 999999.
16
Multifunction Counter
Input mode
UP/DOWN A, B, C
H7BX
(The one-shot output time
can be set in the range 0.01
to 99.99s.)
Self-holding Instanta- One-shot
output neous output
(equals)
output
Operation after count completion
The display continues to increase/
decrease until the overflow or
underflow value is reached.
Only a one-shot output is possible.
The display continues to increase/
decrease until the overflow or
underflow value is reached. The
outputs are ON while the count is
equal.
The display continues to increase/
decrease until the overflow or
underflow value is reached.
OUT1 is held while the present value
is less than or equal to set value 1.
OUT2 is held while the present value
is greater than or equal to set value 2.
The display continues to increase/
decrease until the overflow or
underflow value is reached.
OUT1 is held while the present value
is greater than or equal to set value 1.
OUT2 is held while the present value
is greater than or equal to set value 2.
Note: H mode is available only when
using a 2- stage counter.