Lectrosonics DSSM-A1B1 Quick Start Manual page 11

Powering Off
Holding the Power Button
fully will turn the power off.
Powering
Off...
If the power button is released before the countdown is completed, the unit will
remain turned on and the LCD will return to the same screen or menu that was
displayed previously.
Setup Steps
The top level menus are accessed by powering the unit on, then pressing
MENU/SEL. Refer to the Setup Screens section for details of each setup
parameter.
The following list outlines the steps necessary to set up the transmitter for
normal use.
1) Install a charged Lectrosonics LB-50 battery or retrieve the charged unit
from the charging dock.
2) Set the compatibility mode to match the receiver to be used by pressing
MENU/SEL, then scrolling to COMPAT and pressing MENU/SEL again
to choose either D2 or HDM.
3) Adjust the frequency to match the receiver by using IR sync or press-
ing MENU/SEL, then XMIT, then FREQ. Use the arrow buttons to scroll
through the first set of digits, then pressing MENU/SEL to choose and
go to the next set of digits. Press MENU/SEL choose.
The frequency is normally determined using the receiver to identify one
within clear operating spectrum. Refer to the receiver instructions for
details on using features such as scanning.
4) Connect the microphone or audio source to be used. Select the correct
input configuration.
5) Adjust the input gain. Refer to the Adjusting the Input Gain section on
the following page for instructions.
6) Turn on the receiver and verify that solid RF and audio signals are pres-
www.lectrosonics.com
in and waiting for the bar counter to decrease
11