Wittkopp Primor 100 Manual

Primor 100
Manual Primor 100
DRS Vector and DRS Vector Keysafe (XL)
General instructions
The lock operates with a 6-digit code. Every entry of
a code is confirmed by a signal consisting of a beep
and the light up. After a valid code a double signal
follows, if the code is invalid a long signal follows.
With a pause of more than 10 seconds, the code
entered so far disappears and the entire code must
be entered again.
Opening
Enter code, 1-2-3-4-5-6 (factory code). Turn the
keyboard to the right. Unlock the safe door (within 3
seconds) and open it.
Locking
Close the door and turn the keyboard fully to the
closed position. The lock is closed. You can test the
block for checking.
Manipulation block
After four times an incorrect code, the keyboard is
locked for 5 minutes. A signal is given every ten
seconds during this period. If an incorrect code is
entered twice again after the blocking period, the
waiting time starts again.
Safety warning: all codes must be stored safely.
Don't use any personal records (like birthdays, pho-
ne numbers, etc.) as a code for your safe. Make
sure you always change the factory code before you
start using the safe.
Changing the master code
Please test with the door
open!
Keep "0" pressed until
repeated double signal
follows, LED stays on during
change:
Enter old code
Enter new code (double tone)
Enter new code again (double
tone)
With an input error (long
tone) the old code remains active. Note: test the new
code for closing the door. If the new code does not
work, try the old code and repeat the "Change code"
procedure.
Adding a user code
Press '1' until the LED turns
red.
Enter the master code.
Enter the user code twice.
When you hear two beeps,
the code has been activa-
ted. When you hear one
long beep you should try
again.