Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual page 479

OMRON
Downloading Ladder Programs or Other Data to a PLC with a USB Connection between the
Computer and PT and a 1:N NT Link Serial Connection between the PT and PLC
Revision 2.0
4. Click the Network Tab and set the following items.
Item
FINS Source Address
FINS Destination Address
Node
5. After completing the settings, connect online and transfer the ladder programs or other data.
CX-Programmer
USB
1. Start the CX-Programmer.
2. Set the network type in the Change PLC Dialog Box to NS-Thru (USB) port and click the Set
Button.
3. Click the Network Tab in the Network Setting Dialog Box and set the following items.
Item
FINS Destination Address
Node
Note: Data cannot be transferred normally if any value other than 1 is set.
4. After completing the settings, connect online and transfer the ladder programs or other data.
Input the network number of the network connecting the
computer and PT.
Input the network number of the network connecting the PT
and PLC.
Input the node number of the Controller Link Unit connected to
the PLC.
NS-series PT
Serial
Input 111 if the PLC is connected to serial port A on the PT.
Input 112 if the PLC is connected to serial port B on the PT.
Input 1 (fixed). (See note.)
PART 3: CX-Server Runtime
CHAPTER 3 – Communications
Description
PLC
Description
CX-Server Runtime_Page 35