Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual page 173

OMRON
Note: If the drop-down list is displayed without any search item input in the Symbol/Address Input field, all
5 Select one of the symbols from the drop-down list and click the Enter Key or the OK Button to
Symbol Filtering Targets
Target Symbol Table:
Target Symbol (Data Type):
Target Data:
Use the following procedure to edit instructions in detailed dialog mode.
1, 2, 3...
symbols that can be used will be listed.
input the selected symbol in the Symbol/Address Input field.
• When a symbol or address containing a symbol name is selected, the symbol is entered in the
Symbol/Address Input field.
• When an address_comment without a symbol name is selected, the address is entered in the
Symbol/Address Input field.
1. Double-click on the instruction field in the Ladder program. The Edit Instruction dialog is
displayed.
Provides the symbols/addresses registered in the global symbol
table and the local symbol table for the current program.
Note: When a symbol with the same symbol name is registered
in both the local symbol table and global symbol table,
only the symbol registered in the local symbol table will be
displayed in the drop-down list.
The target symbols are BOOL type ones for BOOL type operands
and ones with data types other than BOOL for CHANNEL type
operands.
Select Tools – Options, and select the target data for filtering text
strings from the following options in the Symbol filtering field of
the Diagrams Tab (the default is to filter (search) both symbol
names and I/O comments.)
• Name: Only symbol names are searched.
• Comment: Only I/O comments are searched.
• Both: Both symbol names and I/O comments are searched
(default).
PART 1: CX-Programmer
CHAPTER 4 – Reference
CX-Programmer _Page 93