For Cs/Cj/Cp-Series - Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual

PART 2: CX-Server PLC Tools
CHAPTER 5 – Data Trace/Time Chart Monitor Component

For CS/CJ/CP-series

Trace
Parameter Settings of Data Trace for CS/CJ/CP
Following is the Parameter setting method of Data Trace for CS/CJ/CP.
Display [Data Trace Configuration] dialog box.
1 Select [Data Trace] from [PLC] menu on main window (in the case that Data Trace Window is already open
and Time Chart Monitor is selected, [Operation]|[Mode]|[Data Trace]).
2 Select [Operation]|[Settings] on Data Trace window.
[Data Trace Configuration] dialog box will appear as follows.
[Import]
[Export]
[Transfer (PC to PLC)]
[Transfer (PLC to PC)]
[Compare]
[OK]
[Cancel]
3 Click on the items to be set.
4 Click on [Transfer(PC to PLC)] or [OK] after all settings are done.
The setting details of each tab will be discussed later.
CX-Server PLC Tools_Page 52
Button
For reuse of the parameters of Data Trace used in the past.
Save the parameters of the present Data Trace in a file (*.csv).
Write parameters of Data Trace to PLC and execute the trace.
When [Start Executing Automatically After Download] is
checked, Write is enabled.
Click on to read parameters of Data Trace already set in PLC.
Use for Re-executing Data Trace under the same setting
conditions.
Compare parameters of Data Trace set in PC and PLC.
End Parameter Edit. Use for finishing Edit without starting Data
Trace.
Delete Parameters of Data Trace after Edit.
Function
OMRON