Manually Setting Data Links - Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual

PART 2: CX-Server PLC Tools
CHAPTER 10 – Data Links
Function Bar
(1)
No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)

Manually Setting Data Links

Follow the procedure described below to create data link tables manually for Controller Link or SYSMAC LINK
data links.
CX-Server PLC Tools_Page 94
(2) (3)
Icon
F1: Help
F2: Node<->Table
F3: Link Start Address
F4: Move Up Area
F5: Move Down Area
F6: Show/Hide Offset
F7: Insert Area
F8: Delete Node
F9: Show Prev Node
F10: Show Next Node
Note: There is no need to create a data link tables when data links are set automatically. For
details on automatic setup, refer to Automatically Set Data Links.
(4) (5) (6)
Displays help.
Moves the focus between nodes and tables.
Moves the focus between settings for the link start addresses
(status, Area 1, Area 2).
Moves a node up the node refresh sequence.
Moves a node down the node refresh sequence.
Shows or hides the offset for the node being displayed.
Inserts a new receive area (new node).
Deletes a node or communications area.
To delete a node or link area from a node list, select the item from
the list and then click F8: Delete Node.
To delete a node or link area from a table, select the item from the
table and then click F8: Delete Node.
Shows the previous node.
Shows the next node.
(7) (8) (9)
Function
OMRON
(10)