Table of Contents
Advertisement
PART 2: CX-Server PLC Tools
CHAPTER 1 – Technical Specification
♦ use the Microsoft Windows desktop environment.
If the installed version of Microsoft Windows has not been used before, it is recommended that the reader spends
some time working with it using the Microsoft documentation before using the CX-Server PLC Tools.
CX-Server PLC Tools: New Features
This version of the CX-Server PLC Tools offers significant functionality for communication with OMRON PLCs
and management of their associated settings information.
System Requirements
The system requirements of CX-Server are the same as those of the CX-Programmer. Refer to page 3
in Part 1: CX-Programmer for details.
Communications Requirements
In order to use serial communication types SYSMAC WAY and Toolbus a RS232 connections via a standard
serial port on the PC (COM1 etc.) or a RS422 connections to a 422 serial board is required.
When using SYSMAC LINK directly from a PC, a SYSMAC LINK network service board and FinsGateway
version 3.12 must be installed.
When using Controller Link, a Controller Link network service board (wired or optical and FinsGateway version
3.12 are required.
In order to use an Ethernet net, an Ethernet card, Windows Sockets software and TCP/IP must be installed and
correctly configured.
Refer to the appropriate hardware system manuals for detailed information about connecting and configuring
these devices for the environment.
Installation
CX-Server and CX-Server PLC Tools can be installed from the CX-One Package CD-ROM or the individual
CX-Programmer CD-ROM. Refer to one of the following manuals for details.
♦ Installing from CX-One: Refer to the CX-One Setup Manual.
♦ Installing from the individual CX-Programmer CD-ROM: Refer to page 4 of Part 1: CX-Programmer.
Starting CX-Server PLC Tools
CX-Server PLC Tools components are normally accessed from the invoking application. However, a number of
tools can be accessed stand-alone from the Start pushbutton on the Microsoft Windows taskbar.
CX-Server PLC Tools_Page 2
Note:
If FINS Gateway is to be used with a CLK/SLK PCI board in the Windows 2000 or
higher operating system the appropriate drivers must be installed. These drivers can be
found on the CX-Server CD under:
(PCI)\.
Note:
The following network types cannot be run on Windows Vista or Windows 7.
- Controller Link for OMRON NSB. Controller Link
- SYSMAC LINK for OMRON NSB. SYSMAC LINK
- SYSMAC NET for OMRON NSB. SYSMAC NET
- CS1 Board for OMRON CS1 PCI board
- Fins Gateway
CX-Net Network Configuration tool.
CX-Server\WDM\CLK (PCI)\ or CX-Server\WDM\SLK
OMRON
Advertisement
Chapters
Table of Contents
