Maintenance; Field Lubrication - Task Force Tips MID-FORCE Instructions For Installation, Operation And Maintenance

Hand held automatic dual pressure nozzles

Table of Contents

9.0

MAINTENANCE

TFT products are designed and manufactured to be damage resistant and require minimal maintenance. However, as the primary

firefighting tool upon which your life depends, it should be treated accordingly. To help prevent mechanical damage, do not drop or throw

equipment.

9.1

All Task Force Tips nozzles are factory lubricated with high quality silicone grease. This lubricant has excellent wash out resistance,

providing long term performance. If your agency has unusually hard or sandy water, the moving parts of the nozzle may be affected.

Foam agents and water additives contain soaps and chemicals that may break down the factory lubrication.

The moving parts of the nozzle should be checked on a regular basis for smooth and free operation, and for signs of damage. IF THE

NOZZLE IS OPERATING CORRECTLY, THEN NO ADDITIONAL LUBRICANT IS NEEDED. Any nozzle that is not operating correctly

should be immediately removed from service. The nozzle can be returned to the factory at any time for a complete checkup and re-

lubrication with silicone grease.

The field use of Break Free CLP (spray or liquid) lubricant will help to temporarily restore the smooth and free operation of the nozzle.

These lubricants do not have the washout resistance and long-term performance of the silicone grease. Once Break Free CLP is

applied, re-application will be needed on a regular basis until the nozzle can be returned to the factory for a complete checkup and re-

lubrication with silicone grease.

CAUTION

Aerosol lubricants contain solvents that can swell O-Rings if applied in excess. The swelling can

inhibit smooth operation of the moving parts. When used in moderation, as directed, the solvents

quickly evaporate without adversely swelling the O-Rings.

LIN-035 May 20, 2024 Rev17

Table of Contents