Impulse Trigger Valve Lubrication; Service Testing; Repair; Exploded Views And Parts Lists - Task Force Tips MID-FORCE Instructions For Installation, Operation And Maintenance

9.3

IMPULSE TRIGGER VALVE LUBRICATION

1. Insert tube from BreakFree into drain hole in pistol grip.
2. With nozzle upside down spray a 2 second burst into the pistol grip.
Holding a rag around the tube here can help keep excess BreakFree
from the outside of the nozzle.
3. Keep nozzle upside down for at least 10 seconds to allow the BreakFree
to flow into the valve area.
4. Check for smooth and free operation of the trigger. Repeat a second
time if needed.
IF THIS PROCEDURE DOES NOT RESTORE SMOOTH OPERATION OF THE IMPULSE TRIGGER SYSTEM,
THEN FACTORY SERVICE IS NEEDED. • 24-HOUR HOT LINE — 800-348-2686 • tft.com
9.4

SERVICE TESTING

In accordance with NFPA 1962, equipment must be tested a minimum of annually. Units failing any part of this test must be removed
from service, repaired and retested upon completion of the repair.
9.5

REPAIR

Factory service is available. Factory serviced equipment is repaired by experienced technicians, wet tested to original specifications,
and promptly returned. Call TFT service department at 1-800-348-2686 to troubleshoot and, if needed, directions for return. A return for
service form can also be obtained at tft.com/Support/Returning-an-Item-for-Service.
Repair parts and service procedures are available for those wishing to perform their own repairs. Task Force Tips assumes no liability for
damage to equipment or injury to personnel that is a result of user service. Contact the factory or visit the web site at tft.com for parts
lists, exploded views, test procedures and troubleshooting guides.
Performance tests shall be conducted on the equipment after a repair, or anytime a problem is reported to verify operation in accordance
with TFT test procedures. Consult factory for the procedure that corresponds to the model and serial number of the equipment. Any
equipment which fails the related test criteria should be removed from service immediately. Troubleshooting guides are available with
each test procedure or equipment can be returned to the factory for service and testing.
WARNING
CAUTION
NOTICE

10.0 EXPLODED VIEWS AND PARTS LISTS

Exploded views and parts lists are available at tft.com/serial-number.
©Copyright Task Force Tips LLC 2002-2024
It is the responsibility of service technicians to ensure the use of appropriate protective clothing
and equipment. The chosen protective clothing and equipment must provide protection from
potential hazards users may encounter while servicing equipment. Requirements for protective
clothing and equipment are determined by the Authority Having Jurisdiction (AHJ).
Any alterations to the product or its markings could diminish safety and constitutes a misuse of
this product.
All replacement parts must be obtained from the manufacturer to assure proper performance and
operation of the device.
19
Holding a rag around the tube here
can help keep excess BreakFree
from the outside of the nozzle.
Figure 9.3
LIN-035 May 20, 2024 Rev17