Changing Pvs From The Word (Multiple-Bit) Monitor - Omron CJ - 10-2005 Manual

Changing Word (16-bit) Present Values
5-5-6

Changing PVs from the Word (Multiple-bit) Monitor

!Caution Always confirm safety before changing data even when working in PRO-
Key Sequence
Operation Example
1,2,3...
100
2. Specify changing the text from the ASCII display.
When " " is displayed, the text on the lower-left of the keys will be input
when keys are pressed.
3. Input the new value and return to Simple I/O Monitor or I/O Multipoint Mon-
itor.
SFT NOT
WRITE
B C
RUN
No OK
This operation converts word (16-bit) present values to multiple-bit (16-bit
binary) format. This operation can be used during Word (Multiple-bit) Monitor.
GRAM mode. The CPU Unit will refresh I/O even in PROGRAM mode. If the
status of a bit allocated to an Output Unit, Special I/O Unit, or CPU Bus Unit is
changed, the load connected to the Unit may operate unexpectedly.
Word (Multiple-bit) Monitor display
CHG
The following example changes the present value of CIO 0001.
1. Access the Word (Multiple-bit Monitor) and bring up the word to be
changed.
2. Press the CHG Key to specify changing the present value.
3. Press the Up and Down Keys to move the cursor to the bit to be changed.
↓
4. Specify the new value.
D00000
CHG
PV
D00000
MONITOR PROGRAM
OK
0
1
SHIFT SHIFT
SET RESET
CIO 0001
0001
11110000S00000R0
0001
CHG
~1110000S00000R0
0001
↑
1111~000S00000R0
0001
1
1111~000S00000R0
Section 5-5
"AB"!
"??"
"BC"
WRITE
NOT
MON
CHG?
CHG?
CHG?