Safety Advice Relating Specifically To Random Orbital Sanders - Parkside PEXS 270 A1 - MANUAL 7 Manual

the device.
Keep cutting tools clean and sharp.
Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and advice, and
the stipulations drawn up for this par-
ticular type of device. In doing this, take
into account the working conditions
and the task in hand.
Safety advice relating
specifically to random
orbital sanders
½
When working in outside areas, pro-
tect yourself against leakage current
by fitting an FI protection switch with
a max. activation rating of 30 mA.
½
Use exclusively an extension cable
that is certified for use outdoors
½
Secure the workpiece firmly.
½
Under no circumstances should you
place your hands next to or in front of
the appliance or on the area to be
worked,
½
In event of danger, immediately re-
move the power plug from the socket.
½
Always run the power cable away
from the appliance to the rear.
½
Ensure that nobody is endangered by
flying sparks.
½
CAUTION! DANGER OF FIRE!
Ensure that the material being
ground and the grinder itself
do not overheat.
WARNING! TOXIC VAPOURS!
Wear safety glasses and a
dust protection mask!
½
When working for extended periods
on wood and, in particular, materials
that produce dusts that are hazardous
to health, connect the appliance to an
appropriate external suction device.
½
Provide for sufficient ventilation when
working plastics, varnishes and paints.
½
Do not soak materials or surfaces to
be worked with liquids containing
solvents.
½
The electric tool must only be used for
dry grinding.
½
Avoid sanding lead-based paints or
other materials that are hazardous to
health.
½
Material containing asbestos may not
be worked.
½
Avoid contact with the moving sand-
ing sheet.
½
Use the appliance only with a sanding
sheet in place.
½
Never use the appliance for purposes
other than those intended and only
with original components / accessories.
½
Introduce the appliance to the work
piece with it switched on.