Instructions For Connecting; Instructions For Disconnecting - Allied Vision FPD-Link III STP User Manual

Instructions for connecting

1. Grab the device (the camera in this example) with one hand and the cable-side
2. Align the groove (b) of the cable-side connector with the notch (a) of the
Figure 10: HSD STP connectors on devices (left) and on cables (right)
3. Push the cable-side connector over the device's connector until it clicks.
The device is connected properly.

Instructions for disconnecting

1. Grab the device with one hand and the cable-side connector with the other
2. With your fingernail, press down the latch (c) of the cable-side connector.
Damage to cameras and connected peripherals
If HSD STP connectors are exposed to excessive stress, they can break off from
devices.
Keep the latch (c) pressed down until the cable has been completely disconnected
from the device.
3. Keeping the latch (c) pressed down, pull the cable-side connector off the
The camera is disconnected.
Figure 11: Pressing down the latch (c) of the HSD STP connector
Deserializer Board FPD-Link III STP to CSI-2 User Guide V1.0.1
connector with the other hand.
device's connector.
a
hand.
device. You may slightly rotate and tilt the cable-side connector against the
device to reduce friction.
c
Setting up deserializer boards
NOTICE
b
38