Download Print this page

BrandMotion 9002-2760 Installation Instructions

Chevrolet/ gmc mylink display radio camera interface harness

Advertisement

Quick Links

Chevrolet/ GMC Mylink Display Radio Camera Interface Harness
(Kit # 9002-2760)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
44 pin Interface Harness
LCD Y Harness
Interface box
These Instructions
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
1. Remove sun visor over display
screen, by pulling up form the front
to unsnap clips.
2760 Instructions 2-8-2016
INSTALLATION INSTRUCTIONS
Tools & Supplies Needed:
Plastic Trim Removal Tool
7mm Socket
Vehicle service manual
Zip ties
2.Remove console front side trim, by using plastic
panel removal tool to release clips. Lift up to
remove trim off console.
Page 1 of 4
(If needed)

Advertisement

loading
Need help?

Need help?

Do you have a question about the 9002-2760 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BrandMotion 9002-2760

  • Page 1 • Only perform this task if confidence, skill, and physical ability permit. NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color instructions, as well as an installation video, please visit www.brandmotion.com 2.Remove console front side trim, by using plastic 1.
  • Page 2 INSTALLATION INSTRUCTIONS 5. Remove the screen, unplug the connectors and set aside. 3. Remove screen trim/ radio control panel by using a panel tool to 6. In the lower part of the dash unsnap clips from the sides. Unplug opening above the cd slot there is a connector and set aside.
  • Page 3 INSTALLATION INSTRUCTIONS 9. Unplug the 44 pin connector from 13. Connect the LCD harness from that the radio, plug the connector into was plugged into the screen to the the female side of the T-harness to the blue connector marked car from the 2760 interface.
  • Page 4 INSTALLATION INSTRUCTIONS 20. This installation was done in a 2013 GMC Terrain as a guide on which connectors have to be plug in and where they should run to. Other vehicles may be different but the connections will be the same. Note the LCD connectors will be done behind the screen on all installs.