Shed & Garage Alarm
(SAA5015 & SAA5010)
⁄
¤
‹
›
Description
1 Motion sensor
2 Alarm speaker
3 Keypad
4 Battery low LED
5 Battery compartment
6 4.5V AC adaptor socket
(AC adaptor not included)
Battery Installation
1 The battery compartment is accessed from
the rear of the alarm unit by removing the
screw from the base and lifting the back
cover (as shown in image B).
2 Insert 4 'AA' size batteries (not included)
following the polarity (as shown in image C).
When the last battery is inserted the alarm will
beep very loudly to indicate that the batteries are
installed properly.
For more information on this product
visit www.yale.co.uk
Consumer Support: info@yale.co.uk
A
fi
‡
6
fl
5
B
3 Replace the back cover and fix with screw.
Note: The Battery Low LED will light when the
batteries need replacing.
Programming the Alarm
Immediately after inserting the batteries, the
desired 4 digit security code must be set, simply
press the desired 4 digits on the keypad.
Note: After removing the batteries, press
number 4 before installing new ones. The alarm
must be re-programmed with your security code
each time the batteries are removed or
replaced.
The 2 year guarantee for this
product is active from the date
2
of purchase (A copy of this
guarantee is available on our
website).
C