STEELGREEN SG46 Instruction Manual
7 gal. independent sprayer attachment
Hide thumbs
Also See for SG46:
- Instruction manual (13 pages) ,
- Operator's manual (80 pages) ,
- Operators & service manual (40 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for STEELGREEN SG46
Summary of Contents for STEELGREEN SG46
- Page 1 INSTRUCTION MANUAL 7 GAL. INDEPENDENT SPRAYER ATTACHMENT Models: SG46, & SG52...
- Page 2 7 GAL. INDEPENDENT SPRAYER EXPLODED VIEW ,LEFT SIDE...
- Page 3 7 GAL. INDEPENDENT SPRAYER EXPLODED VIEW, LEFT SIDE...
- Page 4 7 GAL. INDEPENDENT SPRAYER EXPLODED VIEW, RIGHT SIDE...
- Page 5 7 GAL. INDEPENDENT SPRAYER EXPLODED VIEW, RIGHT SIDE...
- Page 6 7 GAL. INDEPENDENT SPRAYER ASSEMBLY INSTRUCTIONS STEP 1: Disconnect the battery, ground first and then power wire. GROUND POWER NOTE: Steps 2 & 3 instructions are the same for the right and left side, if both left & right side tanks are being installed.
- Page 7 7 GAL. INDEPENDENT SPRAYER ASSEMBLY INSTRUCTIONS STEP 3: Install the independent sprayer to the frame as shown. Hex nuts HFNCS-516S qty. (4) Carriage bolts CB-51634 qty. (4)
- Page 8 7 GAL. INDEPENDENT SPRAYER ASSEMBLY INSTRUCTIONS...
- Page 9 7 GAL. INDEPENDENT SPRAYER ASSEMBLY INSTRUCTIONS STEP 4: Remove the plastic cap from the appropriate “Aux” in the panel. RIGHT SIDE PUMP LEFT SIDE PUMP STEP 5: Attach the rocker switch to the appropriate opening. RIGHT SIDE PUMP LEFT SIDE PUMP...
- Page 10 7 GAL. INDEPENDENT SPRAYER ASSEMBLY INSTRUCTIONS STEP 6: Route the “pump” wiring harness along the frame and upright to the dash panel securing it with zip-ties. STEP 7: Connect the wiring harness to the rocker switch.
- Page 11 7 GAL. INDEPENDENT SPRAYER ASSEMBLY INSTRUCTIONS STEP 8: Connect the ground wire from the “pump” wiring har- ness to the up right cross member. STEP 9: Connect the plug on the harness to the pump on the 7 gallon tank. STEP 10: Reconnect the battery power wire first along with the pump power wire from the wiring harness, and then recon- nect the ground wire.
- Page 12 7 GAL. INDEPENDENT SPRAYER ASSEMBLY INSTRUCTIONS OPERATION STEP 1: Press the switch on the dash to power the pump “on”. STEP 2: Turn the knob on the throttle valve to adjust the spray pressure, STEP 3: Squeeze the trigger on the spray handle to spray.
- Page 13 7 GAL. INDEPENDENT SPRAYER ASSEMBLY INSTRUCTIONS MAINTENENCE • Turn the ball valve off to stop the fluid flow. • Remove the cap from the strainer to clean it.
- Page 14 NOTES...
- Page 15 NOTES...
- Page 16 MADE IN THE USA Steel Green Mfg. 824 S State Road 39 MANUAL MANUAL DESCRIPTION Lebanon, IN 46052 PART NO. REV. PART NO. (765)-481-2890 www.steelgreenmfg.com SGM-012 SG46-52 7 GALLON INDEPENDENT SPRAYER P10030-1...
Need help?
Do you have a question about the SG46 and is the answer not in the manual?
Questions and answers