Page 2
RATE DIAL HOLDER INSTALL INSTRUCTIONS STEP ONE: Remove the clip and spinner. CAUTION! Be sure the hopper is empty before starting the following steps. STEP TWO: Set the rate dial to “6” and measure the gate opening . NOTE: Write down the measurement to be used to install the new dial holder.
Page 3
RATE DIAL HOLDER INSTALL INSTRUCTIONS NOTE: Holes will need to be drilled in gate frame. Step 3 is optional, the gate assembly is siliconed to the hopper tub. It will have to be re-siliconed if removed. NOTE: If you choose to leave the assembly on the unit, remove the hopper shaft to slide the rate dial holder assembly out.
Page 4
RATE DIAL HOLDER INSTALL INSTRUCTIONS STEP FIVE: Disconnect the gate from the guide. STEP SIX: • Insert the guide through the opening of the rate dial provided with the kit. • Re attach the gate to the guide.
Page 5
RATE DIAL HOLDER INSTALL INSTRUCTIONS STEP SEVEN: Slide the new rate dial holder assembly into the frame. STEP EIGHT: • Set the new rate dial to “6”. • Mark the holes on the plate using the measurement from step 2. Use a piece of wood between the plate and tub if left assembled.
Page 6
RATE DIAL HOLDER INSTALL INSTRUCTIONS STEP NINE: • Re attach the assembly to the hopper tub if it was removed. NOTE: Be sure to re-silicone between the rate dial as- sembly and hopper tub. • Re connect the gate and diffuser cables. •...
Page 8
MADE IN THE USA Steel Green Mfg. 824 S State Road 39 MANUAL MANUAL Lebanon, IN 46052 DESCRIPTION PART NO. REV. PART NO. (765)-481-2890 www.steelgreenmfg.com SGM-036 STAINLESS STEEL RATE DIAL HOLDER OPTION K10027...
Need help?
Do you have a question about the SG36 and is the answer not in the manual?
Questions and answers