Page 4
1 GAL. FOAM MARKER ASSEMBLY INSTRUCTIONS STEP ONE: Disconnect the battery, ground first and then power wire. GROUND POWER STEP TWO: Disconnect and remove the fuel tank. CAUTION! -Beware of excess fuel in the lines. -Fuel spillage. WARNING! -Flammable gas.
Page 5
Attach the lower support bracket (supplied with the kit) to foam marker support bracket and the side of the hop- per. 4 CB-1434SS and 4 HFNCS-38S (supplied with the kit). • Once all the bolts are started, they can be tighten. SG36/42...
Page 6
1 GAL. FOAM MARKER ASSEMBLY INSTRUCTIONS NOTE: The SG46/52 uses the same lower bracket. SG46/52 • Attach the foam marker assembly (supplied with the kit) to the support. Use 2 HFSSC-381 (supplied with the kit).
Page 7
1 GAL. FOAM MARKER ASSEMBLY INSTRUCTIONS STEP FOUR: Attach the foam marker bracket to the end of the boom and fasten the foam marker to the bracket with hose clams. HFSSC-1475 (2) & IFI-10.25-20 (2) NOTE: Repeat step three for the other side of the boom.
Page 8
1 GAL. FOAM MARKER ASSEMBLY INSTRUCTIONS STEP SIX: Cut the provided hose to length as needed and route it from the “tee” fitting, along the frame, and connect it to the foam marker pump.
Page 10
1 GAL. FOAM MARKER ASSEMBLY INSTRUCTIONS STEP EIGHT: • Remove the plastic cap from “aux 3” in the panel . • Attach the “rocker switch” to the dash panel. NOTE: The long side of the rocker switch should face down. LONG SIDE •...
Page 11
1 GAL. FOAM MARKER ASSEMBLY INSTRUCTIONS STEP TEN: • Connect the ground wire from the wiring harness to the up right cross member. • Route the power wire neatly down and along the frame to the battery. NOTE: Do not connect the Power wire until all connections are made, (see step fourteen) STEP ELEVEN: Plug the pump power connector from the harness to the foam marker power connector.
Page 12
1 GAL. FOAM MARKER ASSEMBLY INSTRUCTIONS STEP THRITEEN: Reinstall the fuel tank. CAUTION! -Beware of excess fuel in the lines. -Fuel spillage. WARNING! -Flammable gas. STEP FORTEEN: Reconnect the battery, power wire first along with the pump power wire from the wiring harness, and then reconnect the ground wire.
Page 13
1 GAL. FOAM MARKER ASSEMBLY INSTRUCTIONS OPERATION FILLING THE TANK CAUTION! • Wear safety goggles & all proper clothing when operating, servicing or refilling this machine. • Always read & follow manufactures recommendations when handling any chemical. • Do not pump combustible liquids or vapors with this product. •...
1 GAL. FOAM MARKER ASSEMBLY INSTRUCTIONS • Start the machine and activate the foam marker and let it prime until it starts dropping suds. TROUBLE SHOOTING PROBLEM SOLUTION • ADD MORE FOAM CONCENTRATE TO THE TANK. • CHECK FOR HOLES IN THE AIR LINE. •...
Need help?
Do you have a question about the SG36 and is the answer not in the manual?
Questions and answers