Page 2
6 NOZZLE SPRAY BOOM ASSEMBLY SPRAY BOOM VALVES PRESSURE CONTROL CAUTION! Before attempting any of the following, be sure there is no spray pressure and all 3 valves are closed. SPRAY PRESSURE WARNING! Beware of excess fluid in the lines and splash.
Page 3
6 NOZZLE SPRAY BOOM ASSEMBLY • Loosen the hose clamp and disconnect the left side spray hose from the boom. • Loosen the hose clamp and disconnect the cen- ter spray hose from the “tee fitting” on the boom. • Once all three hoses have been disconnected, feed the right &...
Page 4
6 NOZZLE SPRAY BOOM ASSEMBLY STEP TWO: • Remove the 4 bolts and spray boom from the frame. • Attach the 6 nozzle spray boom to the frame.
6 NOZZLE SPRAY BOOM ASSEMBLY NOTE: Instructions are the same for right & left sides. STEP THREE: • Feed and route the left and right hoses through the spray boom. • Connect the hose to the spray nozzle and securely fasten with hose clamp. BOTTOM VIEW STEP FOUR: Connect the center hose to the “tee fitting”...
6 NOZZLE SPRAY BOOM ASSEMBLY OPERATION: LEFT CENTER RIGHT • The 6 nozzle boom is divided the same: Cen- ter, left, and right (Fig 1). • The main controls are the same: Left, center, right valves (Fig 2). NOTE: The spray boom can also be operated with 4 nozzles by turning the valves off located on the spray nozzles (Fig.
Page 8
MADE IN THE USA Steel Green Mfg. 920 S State Road 39 Lebanon, IN 46052 (756)-481-2890 www.steelgreenmfg.com 6 NOZZLE BOOM...
Need help?
Do you have a question about the SG46 and is the answer not in the manual?
Questions and answers