Assa Abloy ACCENTRA 794 Installation Instructions

794 Strike
For Vertical Rod Exit Devices
Installation Instructions
NOTES:
1. Use in combination with Exit Device Installation Instructions.
2. With door open, actuate pushpad to retract upper latch. Attach lower rod to bottom of slide and adjust bolt so that it clears the finished
floor by 1/4". (See Figures 1 & 2 for appropriate Finished Floor application)
3. Verify location of the Flush Mounted Strike Template. Prepare the strike holes (See Figures 1 & 2) and install the 794 Strike (For
"Threshold" door ways, prepare a 1" (25) Dia. hole through the threshold for bolt clearance). Spot and prepare (2) screw anchor holes by
drilling 3/8" (10) Dia. X 1" (25) deep holes & 1" (25) Dia. x 3/4" (19) deep hole. Orient in place and attach with 1/4-20 x 1/2" (13) fasteners
and anchors.
* Install screw anchors: Place the anchor in the prepared hole, place punch through the threaded hole of the anchor, drive with a hammer
until seated, remove punch and install by bolting 794 Strike to floor with (2) 1/4-20 x 1/2" (13) Machine Screws.
4. With door open, actuate pushpad to retract upper latch. Adjust bolt height by pulling the rod out of the guide and slide, rotate until the
bolt clears the 794 Strike by 1/8".
Figure 1
2x 1/4-20 X 1" Anchors
WARNING
This product can expose you to lead which is known to the state of California to cause cancer and birth defects or other
reproductive harm. For more information go to www.P65warnings.ca.gov.
WARNING
Attention Installer: Any retrofit or other field modification to a fire rated opening can potentially impact the fire rating of the
opening, and ASSA ABLOY makes no representations or warranties concerning what such impact may be in any specific
situation. When retrofitting any portion of an existing fire-rated opening, or specifying and installing a new fire-rated opening,
please consult with a code specialist or local code official (Authority Having Jurisdiction) to ensure compliance with all
applicable codes and ratings.
1-855-557-5078 Ext. 2 • www.accentra-assaabloy.com
Copyright © 2004, 2013, 2024, ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved. Reproduction
in whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
2x 1/4-20 X 1/2" Machine Screws
Bottom Strike
Threshold
Base Floor
Figure 2
2x 1/4-20 X 1/2" Machine Screws
2x 1/4-20 X 1" Anchors
Bottom
Finished
Strike
Floor
80-8470-0794-000 04/24