HOMCOM 370-061V00 Manual page 7

1.As shown in the picture, insert the rear wheel
axle into the main frame rear dropout, gently
tap until it locks with a "click" sound.
4.As shown in the picture, first insert the
front wheel assembly into the main frame;
then fit the front basket, and then fit the front
cover onto the handlebar tube, then insert
the handlebar tube into the front fork upper
tube, aligning the front fork screw hole with
the handlebar screw hole. Insert the handle-
bar fixing screws through the tube hole; then
use a socket wrench to tighten them, lower
the front cover; finally, install the bell on the
handlebar.
2.As shown in
picture, fix the
fender to the front fork
with screws (cres-
cent-shaped groove
facing forward).
Insert into hole a, then lay the
steering rod flat.
a
5.As shown in the picture, first unscrew the nut at the
rear end of the steering rod, then insert the front end
of the steering rod vertically into the front fork hole a,
lay the steering tube flat, ensuring a secure connec-
tion with the front fork hole; twist the lower push tube
to adjust push tube hole b so that the rear end of the
steering rod can be hooked into the hole; once
hooked, tighten it with a nut.
7
the 3.As shown
front picture, first insert the
headset into the front fork
and secure it with bolts
and nuts.
Twist the push rod ,and adjust it
to the hole(b)
in the
b