Noise And Vibration - Flex LD 18-7 125 R Original Operating Instructions

LD 18-7 125 R/LD 18-7 150 R
Additional safety instructions
Use only extension cables permitted

for outdoor use.
It is not recommended to sand lead

paint. Lead paint should be removed by
a specialist only.
Do not work on materials which release

hazardous substances (e.g. asbestos).
Take precautions if hazardous, combus-
tible or explosive dust is likely to occur.
Wear protective dust mask.
Use dust extraction system.
DAMAGE TO PROPERTY!
The mains voltage and the voltage
specifications on the rating plate must
correspond.

Noise and vibration

NOTE
Values for the A-weighted sound pressure
level and for the total vibration values can
be found in the "Technical specifications"
table.
The noise and vibration values have been
determined in accordance with EN 62841.
WARNING!
The indicated measurements refer to new
power tools. Daily use causes the noise
and vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured
in accordance with a standardised test
given in EN 62841 and may be used to
compare one tool with another. It may be
used for a preliminary assessment of
exposure. The declared vibration emission
level represents the main applications of the
tool.
However if the tool is used for different
applications, with different accessories
or poorly maintained, the vibration emission
may differ. This may significantly increase
the exposure level over the total working
period.
For a precise estimation of the vibration load
the times should also be considered during
which the power tool is switched off or even
running, but not actually in use.
This may significantly decrease the
exposure level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and the
accessories, keep the hands warm,
organisation of work patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
17