Call From Mobile Station - Wavetek TETRA MS Test Operating Instructions Manual

TETRA MS Test

Call from mobile station

Why?
Requirements
How?
"
You may originate a call to a group or to an individual subscriber, in full or
semi-duplex mode. The dialed number is indicated on the right-hand side of the
screen (Fig. 10.10).
"
In semi-duplex mode, keep PTT pressed in order to maintain the call and to see
measurement results.
10-24
See if the mobile station can originate a call.
!
Proper call setup is a requirement for further tests.
!
Mobile station is registered ("idle updated") and not in a
!
call.
Dial a number on the mobile and press SEND key on
!
mobile, or push the PTT. The mobile initiates a call on
the main control channel and is then handed off to the
selected traffic channel slot. The display shows "Traffic
channel" on the left-hand side and measurement results
on the right-hand side.
Fig. 10.10:
An MS-originated has been established, the
dialed number is displayed along with meas-
urement results.
Modes of operation