Table of Contents
Advertisement
Quick Links
Installation and Service Manual
SUBMERSIBLE PUMP WITH
HAZARDOUS LOCATION
MOTOR END
Model S4MX
NOTE! To the installer: Please make sure
you provide this manual to the owner of
the equipment or to the responsible party
who maintains the system.
For use with product
built with USEM motor.
(Class I, Division 1, Groups C & D): FM
(Hazardous Location
Motor End)
Item # E-03-475
Part # 5625-475-1
© 2011 Pentair Pump Group, Inc.
3/11
Advertisement
Table of Contents
Related Manuals for Pentair HYDROMATIC S4MX
Summary of Contents for Pentair HYDROMATIC S4MX
- Page 1 For use with product built with USEM motor. 3/11 Item # E-03-475 Part # 5625-475-1 © 2011 Pentair Pump Group, Inc.
-
Page 2: General Information
Pump: Heat Sensors: General hazardous location All motors in this family have Information submersible pump family was heat sensors on or embedded designed in accordance with in the motor winding to detect requirements hazardous excessive heat. This prevents Thank you for purchasing your locations. -
Page 3: Pump Installation
Single phase pumps with capacitor impeller should turn freely. Do Pump start have a run and a start winding not connect the power until after each drawing a different current. this test. Operations To adequately protect these Clean all trash and sticks from windings with the appropriate sump and connect pump to piping. - Page 4 TYPICAL FM ONLY SCHEMATICS TYPICAL SINGLE PHASE MOTOR CONNECTIONS PUMP MOTOR WHITE HEAT SENSORS 120 VAC, 5A BLACK SEAL PROBES 300 VAC, 20 MA FUSES CAPACITOR GREEN 330K 120 VAC START CAPACITOR POWER SEE TYPICAL CONTROL CIRCUITRY CORD CAPACITOR BELOW CONTROL PACK PANEL CORD...
-
Page 5: Pump Maintenance
Do not smoke or use sparkable assembly and install protective Pump electrical devices or flames in a cover. (Hydromatic Kit 11456- Operations septic (gaseous) or possible 000-1) septic sump. CAUTiON: Do not reconnect 9. Repeat this operation cycle Field Service on Hydromatic power to a cord and cap assembly several times before leaving job. - Page 6 Do not tape leads as oil will 13.Refill motor chamber with Pump deteriorate the tape and cause oil through connection box Maintenance damage to stator and bearings. opening. Use high grade, non-synthetic transformer oil Hydromatic special 9. Check top bearing. If the bearing submersible oil.
- Page 7 push the bearing from the NOTE: Any time seal 12.Before refilling chamber with housing and will force upper disturbed, replace seal. oil air test as described in seal from shaft. replacing stator. 7. Use bearing puller to remove 13.Refill both chambers with 9.
-
Page 8: Parts List
S4MX Parts List For use with product built with USEM motor. ORDERING REPLACEMENT PARTS: Product improvements are made from time to time. The latest part design will be furnished as long as it is interchangeable with the old part.When ordering replacement parts, always furnish the following information: (1) pump serial number, (2) pump model and size, (3) part description, (4) part number, (5) impeller diameter (if ordering impeller), (6) quantity required, and (7) shipping instructions. - Page 9 S4MX...
- Page 12 STANDARD LIMITED WARRANTY ® warrants its products against defects in material and workmanship for a period of 12 months from the date HYDROMATIC of shipment from Hydromatic or 18 months from the manufacturing date, whichever occurs first - provided that such products are used compliance with the requirements of the Hydromatic catalog and technical manuals for use in pumping raw sewage, municipal wastewater or similar, abrasive free non-corrosive liquids.