Preparing The System For Operation - IBM 9080-HEX Installing

Figure 9. Installing a cassette
d) Have the cable management bracket in the lower position; or allow enough slack in the adapter
cables, before attaching the cable to the cable management bracket.
Preparing the 9080-HEX system for operation after installing an
adapter
To prepare the system for operation after installing an adapter, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. If you installed a cable adapter and want to connect an expansion drawer to your system, continue
with one of the following procedures:
• Connecting an EMX0 PCIe3 expansion drawer to your system (http://www.ibm.com/support/
knowledgecenter/POWER10/p10egp/p10egp_connect_kickoff.htm)
Installing adapters in the 9080-HEX system node 11