Setting Fast Etherchannel In Netware; Deleting A Team; Teaming Options Supported By Operating System And Protocol - IBM Netfinity 10/100 Ethernet Adapters Installation Manual

Setting Fast EtherChannel in NetWare

1. Copy the following lines from the EXAMPLES.TXT (on the IBM Configuration
2. Modify the lines to match your server's requirements.
3. Save the AUTOEXEC.NCF file and restart your computer.

Deleting a Team

To delete a team, comment out the preceding lines and restart the server.

Teaming Options Supported by Operating System and Protocol

Option
AFT
ALB
FEC
26
Netfinity 10/100 Ethernet Adapters: Installation Guide
and Drivers diskette) and paste them into the appropriate files. These
commands assume the IBMAFT.NLM and CIBMFE.LAN files are in the system
directory (SYS:SYSTEM) of your server. (Files must be copied from the IBM
Configuration and Drivers diskette to your server's hard drive.)
Note: The Fast EtherChannel driver (IBMAFT.NLM) must be loaded before the
Netfinity 10/100 Ethernet Adapter, CIBMFE.LAN, or any other LAN driver.
Copy the following lines into the STARTUP.NCF file.
;- Load Fast EtherChannel
load ibmaft
Copy the following lines into the AUTOEXEC.NCF file.
;- Load LAN Driver on 1st Adapter
load cibmfe slot=a frame=ethernet_802.2 name=pri_802.2
;- Load LAN Driver on 2nd Adapter
load cibmfe slot=b frame=ethernet_802.2 name=sec_802.2
;- Bind ipx to 1st Adapter.
bind ipx pri_802.2 net=2
;- Set the 2nd Adapter to be a Fast EtherChannel Partner to
;- the 1st adapter
aft fec a b
Where:
slot Specifies the slot where your Netfinity 10/100 Ethernet Adapter is
installed. If you do not know the slot number, load the driver without it.
NetWare will prompt you with available PCI device numbers.
a Specifies the primary adapter's slot number.
b Specifies the secondary's slot number.
frame Specifies the frame type of the computer's network segment.
Windows NT 4.0
IP, NetBEUI, IPX(NCP),
IPX(NetBIOS)
IP, IPX(NCP)
IP, NetBEUI, IPX(NCP),
IPX(NetBIOS)
NetWare 4.11
IP, IPX(NCP)
IP, IPX(NCP)
IP, IPX(NCP)