Pair Up With The Subwoofer - Philips 6000 Series User Manual

Pair up with the subwoofer

Tips
•
The subwoofer should be within 6 meters,
of the soundbar in an open area.
Automatic pairing
Plug the soundbar and the subwoofer
into the mains sockets and then press
on the unit or remote control to switch
the unit to ON mode. The subwoofer and
soundbar will automatically pair.
» Determine the status based on
the wireless subwoofer indicator.
LED State Status
Fast blink Subwoofer in pairing mode
Solid Connected / Pairing successful
Slow blink Unpaired status
Tips
• Do not press Pair button on the rear of the
subwoofer, except for manual pairing.
Manual pairing
If no audio from the wireless subwoofer
can be heard, manually pair up the
subwoofer.
1
Unplug both the subwoofer and
soundbar from the mains sockets
again, then plug them in again after
3 minutes.
2
Press and hold the Pair button on
the rear of the subwoofer for 3
seconds.
» The indicator on the subwoofer
will rapidly blink.
3
Then press
or remote control to switch the
soundbar ON.
» The indicator on the subwoofer
will become solid when
successful.
4
If the indicator still keeps blinking,
repeat step 1-3.
Tips
•
The subwoofer should be within 6 m of
the soundbar in an open area (the closer
the better).
•
Remove any objects between the
subwoofer and the soundbar.
•
If the wireless connection fails again,
check if there is a conflict or strong
interference (e. g. interference from an
electronic device) around the location.
Remove these conflicts or strong
interferences and repeat the above
procedures.
on the soundbar
EN 13