Connect To Power; Pair Up With The Subwoofer - Philips TAB8505 User Manual

Connect to Power

• Before connecting the AC power cord,
ensure you have completed all other
connections.
• Risk of product damage! Ensure that
the power supply voltage corresponds
to the voltage printed on the back or the
underside of the unit.
1
Connect the mains cable to the AC~
Socket of the unit and then into a mains
socket
2
Connect the mains cable to the AC~
Socket of the subwoofer and then into a
mains socket.
1
For EU
or
For UK
For EU
or
For UK
* Power cord quantity and plug type vary by
2
regions.

Pair up with the subwoofer

3
Automatic Pairing
Plug the Soundbar and the subwoofer into the
mains sockets and then press on the unit or
SoundBar
remote control to switch the unit to ON mode.
The subwoofer and Soundbar will automatically
pair.
AC ~
» Determine the status based on the
wireless subwoofer indicator.
LED State Status
Fast blink Subwoofer in pairing mode
Constant on Connected / Pairing successful
Slow blink Connection / Pairing Failed
Tips
•
Do not press Pair button on the rear of the subwoofer,
except for manual pairing.
Manual Pairing
If no audio from the wireless subwoofer can be
heard, manually pair up the subwoofer.
1
Unplug both units from the mains sockets
again, then plug them in again after 3 minutes.
2
Press and hold the Pair button on the rear
of the subwoofer for 5 seconds.
» The Pair indicator on the subwoofer
will rapidly blink.
3
Press and hold
or remote control to switch the unit to
ECO STANDBY mode
4
Then press on the unit or remote
control to switch the unit ON.
» The Pair indicator on the subwoofer
will become solid when successful.
5
If the Pair indicator still keeps blinking,
repeat step 1-3.
Tips
•
The subwoofer should be within 6 m of the Soundbar in
an open area (the closer the better).
•
Remove any objects between the subwoofer and the
Soundbar.
•
If the wireless connection fails again, check if there is a
conflict or strong interference (e. g. interference from
an electronic device) around the location. Remove these
conflicts or strong interferences and repeat the above
procedures.
for 5 seconds on the unit
13