Pair Up With The Subwoofer; Connect Surround Speakers To; The Subwoofer - Philips 7000 Series User Manual

Pair up with the subwoofer

Automatic pairing
Plug the soundbar and the subwoofer into
the mains sockets and then press
unit or remote control to switch the unit to
ON mode. The subwoofer and soundbar
will automatically be paired.
LED State Status
Fast blink Subwoofer in pairing mode
Constant on Connected / Pairing successful
Slow blink Connection / Pairing failed
Tips
Do not press Pair button on the rear of the
•
Subwoofer, except for the failure of pairing.
Manual pairing
If no audio from the wireless subwoofer
can be heard, manually pair up the
subwoofer.
1
Unplug both the soundbar and the
subwoofer from the mains sockets
again, then plug them in again after
3 minutes.
2
Press and hold the Pair button on the
rear of the subwoofer for 3 seconds.
The indicator on the subwoofer
will rapidly blink.
3
Then press
or remote control to switch the
soundbar ON.
on the
4
If the indicator still keeps blinking,
repeat step 1-3.
•
•
•
Connect surround speakers
to the subwoofer
Use the RCA cables to connect the surround
speakers to the subwoofer, red joint to red
socket and white joint to white socket.
on the soundbar
The indicator on the subwoofer
will become solid when successful.
Tips
The subwoofer should be within 6 m of the
soundbar in an open area (the closer the
better).
Remove any objects between the subwoofer
and the soundbar.
If the wireless connection fails again, check if
there is a con�ict or strong interference (e.g.
interference from an electronic device) around
the location. Remove these con�icts or strong
interferences and repeat the above procedures.
L R
RCA cable
Pair
13
EN