Table of Contents
Advertisement
Instructions for the installer
7.6
Electrical connection
Make sure that the voltage and capacity of the power line conform to the
data shown on the plate located under the casing.
Do not remove this plate for any reason.
The appliance must be connected to earth in compliance with electrical
system safety regulations.
If the appliance is connected to the power grid using a fixed connection, fit
the power line with an omnipolar circuit-breaker, in accordance with the
installation instructions, located in a readily accessible position near the
appliance.
If a plug and socket connection is being used make sure that the plug and
socket are compatible. Avoid use of adapters and shunts as these could
cause overheating and burns.
Operation at 220-240 V~: use an
H05V2V2
-F type three-core cable
2
(3 x 0.75 mm
)
The end to be connected to the
appliance must be an earth wire
(yellow-green)
at
least
20
mm
longer.
The manufacturer declines all responsibility for damage to persons or
things caused by the non-observance of the above prescriptions or
deriving from tampering with any part of the appliance.
16
Advertisement
Table of Contents
