Lancom AirLancer ON-Q30 Mounting Instructions page 4

Mounting Instructions LANCOM AirLancer ON-Q30
Important information
Responsible handling of high frequency
In order to comply with the protection requirements of EU Directive 2014/53 and EN 62479
with regard to the basic restrictions for the safety of persons in electromagnetic fields and the
„FCC Policy on Human Exposure to Radiofrequency Electromagnetic Fields", it is necessary to
configure the correct antenna gain in the WLAN router or WLAN access point.
Electrical and Electronic Equipment Act
Please do not dispose of electrical and electronic waste in household waste, where it cannot
be recycled. Make sure that your electrical and electronic waste is disposed of in accordance
with the currently valid guidelines of your country.
Correct handling of antenna cables
Antenna cables are sensitive RF cables. When laying them, it is therefore important to ensure
that the cables are not kinked and are bent as little as possible, as this can result in losses in
terms of antenna performance. Likewise, the antenna cables should not be wound into tight
cable loops.
Antenna gain and termination of unused antenna ports on access points
Unused antenna connections on the access point must be terminated with an enclosed
rod antenna. For indoor access points, the terminating resistor included with the AirLancer
AN-RPSMA-NJ adapter can be used. In addition, the antenna gain must be specified in the
configuration of the access point.