Table of Contents
Advertisement
3-13-2. BRAKE CONTROL LEVER AND BRAKE ACT
LEVER ASSEMBLY
(See Fig.3-13-2)
1)
Refer to section 3-2 and remove the mechanism unit.
2)
Refer to section 3-15 and remove the wheel gear 2.
3)
Refer to sections 3-12-1, then remove the reel belt and
the reel pulley.
4) Remove the clamp, then remove the wheel gear 1@).
5)
Remove the clutch change spring @.
6)
Remove the clamps@ and ©), then remove the brake
control lever ©.
Remove the clamp@ on the topside
of the mechanism chassis.
7)
Remove the brake return spring @.
8)
Refer to section
3-8 and
remove
the worm
gear
assembly.
9)
Remove the clamp@® and clamp ©, then remove the
brake
act lever assembly@.
To maintain
the
performance of the brake act lever assembly @), do not
disassemble it.
ASSEMBLY NOTES:
1.
Apply grease SGL-505 to the shafts @ and @, to the
teeth of the wheel gear 1@, and to the pin @ of the
brake control lever ©.
2.
Putthe pin @® of the brake control lever® into the cam
groove (4 of the crescent slide.
3.
Before fitting the wheel gear 1 @, align the hole @
with the hole (8 on the mechanism chassis.
4.
Refer to section 3-15 and align the wheel gear 2.
@Pin
@Clutch change
Pg spring
Re
aol
@Brake act
Stine
lever
~~
assembly
. @Brake return
spring
Fig.3-13-2
5-20
3-13-3.S BRAKE ACT SLIDE AND BT SPRING LEVER
ASSEMBLY (See Figs.3-13-3 and 3-13-4)
1)
Refer to section 3-16 and remove the crescent slide.
2)
Refer to section 3-12-1
and remove
the friction gear
assembly.
3) Slide the S brake act slide @ in the direction of the
arrow @), then remove it.
4)
Refer to section 3-11 and remove the BT spring.
5)
Press the BT spring lever assembly @ until it touches
the pin @, then remove it.
ASSEMBLY NOTES:
1.
Apply grease SGL-505 to the shaft
© shown in Fig.
3-13-3, and to the BT spring lever assembly@) and
the S brake act slide @ shown in Fig.3-13-4.
2.
After mounting the BT spring lever assembly@ on the
Shaft @, hook the BT spring onto the clamp © and
press it until it touches the pin ®.
3.
Make sure that the clamps@, @) and @ have snapped
into the S brake act slide @. Align the arrow
on
the S brake act slide @ with the arrow @ on the
mechanism
chassis.
@ Arrow on mechanism chassis
@BT spring
«—
lever
assembly
7
| ®Clamp
WArrow/
QS brake act slide
®Clamp
ig
@Pin
Fig.3-13-3
"ppl
arease
Apply grease
@)S brake
On
2 on! sprine
act
eve
slide
\
assembly
Apply grease
Fig.3-13-4
Advertisement
Table of Contents
