Table of Contents
Advertisement
3-
1)
2)
3)
4)
@ACE
head
connector
2. MECHANISM
UNIT
(See Figs. 3-2-1 and 3-2-2)
Remove the top cover, bottom cover and front cabinet
assembly.
Unplug the flat cable@ from the VM-1/VP-1
PWB
assembly
on the cylinder (drum),
and unplug
the
ACE head connector @.
Remove the screw @), the two screws @), then remove
the VM-1/VP-1 PWB assembly ©), lifting it upwards.
The shape of the VM-1/VP-1
PWB assembly and the
bracket varies according to the model.
Remove
the four screws@ and the two screws (0,
then lift up the mechanism
unit. The tray@ will stop
you
removing
the
two
screws
© on
the front,
so
release
the lock by pressing down the tray lock lever ®
and the lid opener lever @ shown in Fig.3-2-2, then
slide off the tray@.
Move
the tray by referring to
section
3-1 and turn the loading
motor
in the PLAY
direction.
©Screw
@Flat cable
Bracket
Fig.3-2-1
®Tray lock
lever
ES
s
@Tray
Fig.3-2-2
5-8
3-3. CASSETTE DRIVE MECHANISM
3-3-1. CASSETTE MECHANISM ASSEMBLY
1)
2)
3)
(See Figs.3-3-1 and 3-3-2)
Put the VCR into EJECT mode.
Remove the two screws QQ).
Lift up the back of the cassette mechanism assembly
@ slightly, and remove the two hooks @) on the front.
ASSEMBLY NOTES:
1.
The cassette mechanism assembly and the mechanism
chassis should both be fitted in EJECT mode.
Check that the two hooks @ have snapped
into the
mechanism chassis, and make sure that the two holes
@ in the cassette
mechanism
assembly
are aligned
with the two dowels G) on the mechanism chassis.
Make
sure that the big tooth on the pinion gear of
the cassette mechanism
assembly slots properly into
the deepest gap in the start rack gear, as shown
in
Fig.3-3-2.
When fitting the two screws (), use the torque gauge
screwdriver (VHJ-0014). Give the screws a tightening
torque of 5 kg/cm.
9Q-- @Screws
| Mechanism
chassis
Zs
@Hook
@Hole
Fig.3-3-1
Ensure correct
interlocking
Pinion gear
Fig.3-3-2
Advertisement
Table of Contents
